LITLIQ EC51 Rigid ABS Like Printer 3d Resin UV 405nm Fast Printing 3D Printer Resin For Photon Elegoo Anycubic Resin 3D Printer

Attention: The shelf life printed on the labels of some resins is 1 year. In fact, all RESIONE resins can be used normally for 2 years.

EC51 is a standard 3d printer resin that can achieve fast printing, and it supports up to 0.2mm layer thickness 3d printing. EC51 resin 3d printed parts are easy to release from the FEP film, when adding supports, the fault tolerance rate is high and the supports are easy to remove, so the 3d printing success rate is high. It is a resin that is very friendly to novices.

▌ Attention

If white matter appears on the surface of the print, please increase the light-off delay time.

Make sure the prints are evenly exposed to UV light. Both the front and back of the print should be cured.

▌ Features

【Fast printing】EC51 resin has fast curing speed and supports 0.2mm layer thickness printing. If you don’t mind the surface quality of the prints, the printing time of the same model with 0.2mm layer thickness is 1/4~1/3 of the printing time of other resins with 0.05mm layer thickness.

Good mechanical strength

Compared with other standard resins, the tensile strength, flexural strength, elongation at break and notched impact strength of EC51 resin are all good and balanced.

Friendly for novices

EC51 resin 3d printed parts are easy to release from the FEP film, when adding supports, the fault tolerance rate is high and the supports are easy to remove, so the 3d printing success rate is high. In addition, EC51 prints are also easy to clean.

Components do not settle

The components in the EC51 resin liquid will not settle for a long time, and the printing results are stable and consistent.

Broad adaptability

EC51 resin is suitable for all mainstream LCD/MSLA/DLP 3d printers on the market, including RGB or Mono screen printers.

▌ Cleaning and Post-curing

Cleaning tools: Soft brush or Ultrasonic cleaner or 2 in 1Wash Cure Machine

Cleaning time: 30s

Cleaning solvent: 95% Ethanol or IPA

Post-curing light source: 385-405nm UV(40W)

Post-curing time: 3min